About ADC
video introduction
~2.50 min. long
ISO Cert
3-Axis Hall Probes

ADC has developed a 3 axis hall probe based on the popular ESRF design. This probe uses the same FW Bell GH-700 hall sensors but with the addition of an on board RTD for temperature measurement. In addition, ADC has designed this probe using 4 layer board technology. All signals lines are embedded between two layers of copper to reduce noise. While the 4 layer board is the same thickness, the extra layers make it mechanically stiffer. The fit and form factor is the same as the ESRF probe so that existing mounting and calibration fixtures can be used. The 10 pin, 2.5 mm pin spacing connector has been replaced with a 12 pin 1.5 mm connector. An adapter cable is used to interface to existing cable connections.